Phone (303) 651-3794
www.BPEsolutions.com
Blue Point Engineering
Custom Equipment, Unique Electronic Products
Wizard - 11 Controller Board
Troubleshooting Hints Cont.
•
When I playback a sound recorded the audio is bad.
Adjust the sound level from the sound source, to mid range or lower Do not over drive the sound source
output sound level volume as this will cause audio distortion in recording to the sound chip.
How can I erase the sound chip?
Recording a new set of sounds, is really the only way to full erase the sound chip.
I get a hum or strange noise recorded within my sound ic chip recording?
Make sure that you have a good quality audio cable connected from the sound card to your sound source.
Check to see that your original sound source does not have the extra noise in it.
Do not over drive the sound source volume when recording to the sound chip.
Make sure that there are no power sources or signal creating sources around,. across, or near your audio
cable.
I am having trouble getting the board to trigger by a remote sensor.
Check to see that you have the sensor connected to the REM terminal and not the Sync terminal. The
Sync terminal is used to activate other Wizard Boards connected to the Wizard - 11 board.
Check out the Blue Point Engineering web site for more information.
www.BPEsolutions.com
•
•
•
