IMPORTANT NOTE: Clearing Memory
When clearing memory, only the servo and digital output recorded actions are erased.
The sound IC chip can only be cleared by re-recording over the current sound.
You must re-set Servo - 2 travel end point after clearing memory each time, if using AutoTalk
Feature. Servo - 2 will not respond under sound activation if you have not re-set the travel points,
after doing a clear memory.
Clearing Memory
The Enable jumper must be set at the (E) position and the Record-key jumper also set to the (E) position.
The LOOP switch and the AUTO switch must be in the "N" position.
Remove Power to the Wizard - 11 Board.
Hold down the RECORD - key and re-apply power back to the board, released after power is applied.
LED's "1-4" will form a count down bar-graph indicating that current programmed
EEPROM memory is being cleared. (This will take approximately about 20 seconds).
After the initial 20 seconds all green LED’s will turn OFF and the current selected
channel LED will turn ON, indicating the board is now ready for new programming.
The servo and digital
Reset of Servo - 2 Travel End Points.
Setting Servo - 2 travel end points
Select the required audio source (On-board chip or line input jumper)
Set the servo travel end points for servo - 2. Press and hold the NEXT key and apply power to the board.
LED -1 will start to flash and servo - 2 can be controlled by the Position potentiometer. Move the servo to one
end point of the required servo travel range. Press the Digital button.
LED -2 will now flash - adjust the servo position to the other end of the servo limit and press the Digital
button.
LED -2 will now turn off and the control board will return to a normal operation mode ( LED-1 will turn on).
The two servo limit travel points have been stored in memory and will limit the travel of Servo -2 when
responding to an audio signal.
The degree of Servo - 2 movement is governed by the combination of the sound source volume and the Gain
presets. Rotate the Gain potentiometer on-board, clockwise for maximum signal gain and maximum servo
movements.
I am trying to get Servo - 2 to operate from the sound IC Chip, or from a Line Input remote audio
source, but the servo is not moving to any sound.
Check to see that the Servo - 2 EEprom / Audio jumper is set at the (Audio) position.
Check to see that the Audio Source jumper is set at Chip for playback from the on-board IC Chip or
is set to Line for a remote audio input signal.
Check to see that you have a good remote sound source for Line input.
Check the Audio cables from the sound source to the Wizard - 11 Line Input Jack.
Check to see that the Sound IC has the recorded audio needed.
The degree of Servo - 2 movement is governed by the combination of the sound source volume and
the Gain presets. Rotate the Gain potentiometer on-board, clockwise for maximum signal gain and
maximum servo movements.
Reset new travel endpoints for Servo - 2 (See Reset of Servo - 2 Travel End Points)
Problem Help Guide - Audio Servo
Q
A
•
•
•
•
•
•
•
Phone (303) 651-3794
www.BPEsolutions.com
Blue Point Engineering
Custom Equipment, Unique Electronic Products
Page 6
•
See Wizard - 11 Controller Troubleshooting Hint pages for additional help.
