Ô
Ô
Ô
Ô
Ô Ô
Ô
Ô
Page 7 of 9
292-2865 Rev. H
12/7/10
15. On the driver’s side, insert 3/8-16 nut plates
through frame end hole. Align to the lower two
drilled holes (see white arrows). Install
3/8-16 x 1 ½” hex bolts with 3/8” lock washers
and tighten. Trim excess nut plate wire.
Remove air bag sensor bolt (see grey arrow).
15
15
17
17
16. On the passenger’s side, align baseplate
with washer reservoir hole and insert existing
bolt (see white arrow). Using the baseplate
as a template, drill three holes into the frame
rail with the 13/32” drill bit (see grey arrows).
Insert 3/8-16 nut plates through frame end
hole. Insert 3/8-16 x 1 1/2” hex bolts and 3/8”
lock washers and tighten to nut plates . Trim
nut plate wires. Remove washer reservoir bolt.
18. On the driver’s side, reinstall air baffl e’s
existing bolts to upper rear and lower middle
baseplate holes (see grey arrows). Reconnect
horn cable to air bag sensor. Reinstall sensor
to the top front baseplate hole and insert
sensor pin to lower front hole. Reconnect
electrical grounds with the 6mm hex bolt and
1/4” lock washer (see white arrow).
17. Reinstall metal bumper and bracket. Route
the horn cable through the side of the metal
bumper and out through backside of the metal
bumper (see white arrows). Connect the horn
cable (see grey arrow).
16
16
18
18
Ô
Ô
Ô Ô
Ô
Ô
Ô
Ô
Ô Ô
Ô Ô
BE SURE TO USE LOCTITE
®
RED ON ALL BOLTS
BEFORE TIGHTENING. TIGHTEN ALL BOLTS
ACCORDING TO THE TORQUE CHART ON THE
FRONT PAGE OF THESE INSTRUCTIONS OR ON
PAGE 3 OF THE BASEPLATE TOWING GENERAL
INSTRUCTIONS.
Ô
Ô
Ô Ô
Ô Ô
2006-11 Hyundai Accent
(No Foglights) Installation Instructions
BX2323