13
FlexCoder
Instruction Manual
4.4 ”Main > TS Map” Screen (continued)
Selection Control (Add):
Select the desired programs from Input TS’s under the green header (#1) for each
output TS (TSO#) using the “Selection Control” and click on the “Add =>” button.
Selection Control (Remove):
to remove programs from the Output, click on the check box and then click
the “<= Remove” button .
TS Map configuration is not available under this mode, please continue on to section 4.5.
The setting parameters are the same between DEMUX and MUX modes with the exception of the number of Input
and Output TS’. The DEMUX has (4) Input TS’ with up to (32) Output TS’ whereas the MUX Mode is the complete
opposite with (32) Input and (4) Output TS’s.
1
2
2a
2b
A
B
Demux (Figure 4.4a) & Mux (Figure 4.4b) Modes
Pass-Thru Mode
NOTE: A “Red” Flag will apear when a transport stream is not detected. (See Figure 4.4b)
