5
Clearview 4:2 SD
Quick Guide
Step 4: Basic Configuration (continued)
REMINDER
If the IP Address is changed, the procedure in Step 3 must
be repeated using the new IP address in place of
the default IP address in order to re-access the control panel.
IMPORTANT
A reboot is required after applying a configuration file.
The user is also able to reboot the unit and upload/download configuration files. Once downloaded, the settings can be
applied to the unit or the user can choose to set the unit back to the default factory settings with a click of a button.
System Settings
Go to the “
System
” tab to change the System Settings, including unit identification and network settings.
This section provides status messages, temperatures, and fan RPM for the Host system as well as each transcoder used.
The page also features a recent logged message box beneath the main status area which shows the 10 most recent entries
within the Event Log. To see a more in-depth log of event messages, click the “
Log
” tab located on the right side of the
navigation menu at the top.
System Page - Full View
The following Ethernet Settings can be changed: IP address, Subnet Mask, Default Gateway, and the Primary and Secondary
DNS. In addition, the network settings for each transcoder slave are individually configurable. Click “
Apply Settings
” in order
to save new or changed settings.
This section allows the user to individually configure the network settings for each numbered transcode pair (XC1 to XC12).
When using in conjunction with the Technicolor COM3000/2000, the IP address of the transcode pair (XC1 to XC12) MUST
correlate with the IP Port address settings on the “
Overview
” Tab located on the COM3000/2000.
(See Section 6.2 of the
Manual for more details)
Transcoder Ethernet Settings
