9
NXG-EPG
User Manual
Section 4 – Setting up the Network IP Configuration
For this step, you
MUST
set the network configuration in two places within the module, as explained below in the following
sub-sections.
4.1 Before You Begin
4.2 Network IP Configuration
In the module example used here, the IP address of the Master Controller, for remote control of the NeXgen, is set to
172.16.181.55
. Because of this, the EPG module should be on the same subnet with a different Host ID.
As shown above, the EPG has been set to
172.16.181.250
. This is due to the 250 host ID being available in the network
the NeXgen is currently set up in.
Navigate to the “
EPG Module > System
” tab (Figure 4.2a) and then set the IP address of the EPG module to be on the
same subnet as the Master Controller's subnet. Press the [
Apply Settings
] button to finalize the changes.
1
1
2
3
Figure 4.2a - “System” Tab
Next, click on the “
Guide >
Source
” tab and set up the EPG Data Provider and the IP address (and username/password)
for the remote FTP to obtain the Guide data.
2
3
1
Figure 4.2b - “Source” Tab
2