background image

6

OPERATION

Operating Instructions

OPERATION

When set to ON, your steamer has been factory set to 

maintain the generator standby temperature just below 

the boiling point, approximately 205 degrees Fahrenheit, 

in READY mode.

CONTROLS
Main Power Switch:

ON

Boiler will automatically fill with wa

-

ter and begin heating to STANDBY 

temperature.

OFF

The boiler will drain.

DELIME

Closes the drain valve while CLR 

liquid is being poured into the gen-

erator during the delime procedure.

Ready Light

When lit, indicates steam genera-

tor has reached 205 degrees Fahr-

enheit and is ready for the cooking 

cycle.

Cooking Light

When lit, indicates that a cooking 

cycle is in progress.

Timer

Set the cooking time (0 to 60 min-

utes) - steam cooking will begin 

when the door is closed. The cook-

ing cycle will be interrupted if the 

door is opened during the cook-

ing cycle; resume cooking by clos-

ing the door. When done, a buzzer 

sounds and steam stops being sup-

plied to the cooking chamber. Turn 

timer OFF to stop the buzzer.

PREHEAT

Turn the main power switch ON. When the ready light 

comes on, set the timer to 1 minute to preheat the com-

partment. This should be done when the steamer is first 

used for the day or whenever the chamber is cold. The 

door should be closed during the preheat cycle. COOK-

ING light is lit.
When the buzzer sounds, turn the timer to OFF. The 

steamer is now ready to cook.

COOK

After the preheat cycle, the READY light should be ON.
Place pans of food in the cooking chamber. Close the 

door.  Set  the  timer.  Steam  flows  into  the  compartment 

and the COOKING light is lit. Opening the door will inter-

rupt cooking; resume by closing the door.
At the end of the cooking cycle, the COOKING light goes 

off, the buzzer sounds and steam stops being supplied to 

the cooking chamber. To stop the buzzer, turn the timer 

to OFF.

SHUTDOWN

Turn the main power switch OFF – the boiler will auto-

matically blow down. Leave the compartment door open 

to allow the inside to dry out.
For an extended shutdown, turn the main power switch 

OFF, turn power and water supply OFF.

Each compartment is equipped with a removable 

drain screen. Frequently check the drain screen for 

accumulation of food particles. Should food particles 

accumulate against, or clog the drain screen, remove 

it, clean it thoroughly and then replace it in its original 

position.

Frequently check that the compartment drain and plumb-

ing is free of all obstructions. Never place food contain-

ers, food or food portion bags in the cooking compart-

ment in such a way that the compartment drain becomes 

obstructed.

CONSTANT STEAM FEATURE - OPTIONAL

A switch has been added to control this feature. It is locat-

ed below the timer under the heading “COOKING MODE”.

Operation for Timed Cooking

This switch must be positioned to the right, towards the 

heading “TIMED COOKING”. The operator then must se-

lect the time required for the cooking by setting the timer 

dial to the desired time from “0 to “60” minutes. At the end 

of the cook time an audible buzzer will sound.

Operation for Constant Steam

The switch must be positioned to the left towards the 

heading “CONTINUOUS COOKING”. This mode will pro-

vide continuous steam to the cooking chamber until the 

operator either turns the selector switch to the “TIMED 

COOKING” position, or turns the power switch to the 

“OFF” position.

SHUT DOWN

Turn timer dial to the “OFF” position. Turn main power 

switch to the “OFF” position.
For an extended shutdown, turn the main power switch 

off, turn power and water supply off.

Summary of Contents for SN-3E
















Reviews: