Operation
37
IQ Control
Programming the oven size
1. The top display reads
APPL
. The bottom disĆ
play reads either
FULL
or
HALF
. Press the
TOGGLE/CLEAR KEY (10) until the bottom
display reads
HALF
for the CTBRĆAP.
2. Press the SCAN KEY (14) to enter the oven
size and continue with exiting the programĆ
ming mode.
Exiting the programming mode
1. The top display reads
SYS
. Press the PROG
KEY (9). The control returns to the operating
standby mode.
Parameter
KFC Default
Hold mode
NO
Setback
NO
Temperature Units
_
F
Appliance Size
HALF
Programming the Offset
Call Blodgett service for offset programming inĆ
structions.
REPLACING THE RECIPE CARD
1. Remove the two screws from the top and botĆ
tom of the control panel cover. Remove the
cover.
NOTE: Inspect the control gasket. If damaged
call Blodgett service for replacement.
2. Pull back the control decal.
3. Remove the old recipe card.
4. Insert the new recipe card.
5. Replace the control decal.
6. Replace the control cover.
7. Reinstall the screws.
ERROR CODES AND ALARMS
NOTE: The error codes will appear in the top disĆ
play. All error codes are accompanied by
an audible alarm.
Hi
Oven temperature is more than
40
_
F above the highest setpoint.
Prob
Probe failure.
HEAT ERR
From a cool start (below 130
_
F), the
oven takes more than 6 minutes to
climb from 150Ć300
_
F. Press the
TOGGLE/CLEAR KEY (10) to clear
the prompt. This code indicates a
problem with the system. Contact a
service technician.
FAN ERR
Indicates a fan failure during a call
for heat. Press the TOGGLE/CLEAR
KEY (10) to clear the alarm. The FAN
ERR display remains active. Press
the TOGGLE/CLEAR KEY (10) again
to clear the message and return the
system to normal operation. If conĆ
dition persists turn off the oven and
contact a service technician.
FANC ERR
Indicates a contact failure has ocĆ
curred in the fan control circuit.
Press the TOGGLE/CLEAR KEY (10)
to clear the alarm. The FANC ERR
display remains active. Press the
TOGGLE/CLEAR KEY (10) again to
clear the message and return the
system to normal operation. If conĆ
dition persists turn off the oven and
contact a service technician.
DOOR OPEN
The controller senses the door is
open. Close the door. If the door is
closed contact a service technician.
