Installation
9
Oven Assembly
Stacking a CTBRĆAP on top of a Mark V
1. Lay the Mark V on its back.
2. Remove the 25" legs. Pry the casters out of the
old legs.
3. Attach the 6" legs with casters as follows:
NOTE: The locking casters must be installed
on the front of the oven.
a.) Align the threaded stud in each leg with the
nut located inside each bottom corner of
the oven frame. Turn the legs clockwise and
tighten to the nearest full turn.
b.) Align the two leg plate holes in each leg
with those in the oven bottom. Secure
each leg using two 1/2" bolts.
c.) Pry the foot out of the 6" legs. Snap the
casters into the legs.
d.) Tip the oven up on the casters.
Attaching the 6' legs and casters
Figure 5
4. Remove the crown trim from the Mark V.
5. Bolt the stacking plate to the top of the Mark V
with the studs facing up. See Figure 6.
6. Reinstall the crown trim.
7. Lay the CTBRĆAP on its back. Attach the self
adhesive gasket tape to the front and side
edges on the bottom of the unit. See Figure 6.
8. Set the CTBRĆAP upright on top of the Mark V.
9. Remove the control compartment cover and
access panel from the CTBRĆAP.
10. Align the front and rear bolt holes of the CTBRĆ
AP with the studs on the stacking plate. See
Figure 6.
11. Place a nut and washer on each of the studs
and tighten securely.
12. Replace the control compartment cover and
access panel.
13. Insert the flue extension over the flue on the
Mark V. Attach using screws provided.
NOTE: If the oven has a vent guard it must be
removed before installing the flue exĆ
tension.
14. Place the flat plate of the flue brace on top the
CTBRĆAP. The two holes in the end of the
brace must line up with the holes in the flue exĆ
tension. Attach the flue brace to the flue extenĆ
sion with the screws provided.
15. Place the top cap on top of the CTBRĆAP.
NOTE: This will secure the flue brace.
Oven Leveling
1. Place a level on top of the oven. Loosen the set
screws on the side of each caster. Turn the adĆ
justment collar clockwise to raise and counter
clockwise to lower the oven.
2. When the oven is level, tighten the casters by
turning the two set screws on the side of each
caster assembly.
