Installation
13
Optional Leg Attachment
LEG OPTIONS
Legs are available in 4” (10 cm), 6” (15 cm) or 25”
(64 cm) lengths or low profile casters. The 4” legs
are for counter top installations. The 6” legs are
used on the lower section of a double stacked unit.
The 25” legs are used for a single oven located on
the floor.
NOTE: For safety reasons, casters must not be
used with the 25” (64 cm) legs.
25“ (64 cm) Adjustable Leg
4” (10 cm) Leg
6” (15 cm) Adjustable Leg
Low Profile Casters
Figure 5
LEG ATTACHMENT
NOTE: If low profile casters are used, install the
locking casters on the front of the oven.
The rear casters do not lock.
Be sure the
locks are set on the front casters.
1. Align the threaded stud the each leg to the bolt
holes located in the unit’s bottom corners.
Turn the legs clockwise and tighten to the
nearest full turn.
2. Align the leg plate holes with the bolt holes.
Secure with the two 1/2” bolts provided.
3. Tip the oven up on the legs.
If casters are
used, check that the locks are set on the front
casters.
4. Except for units with casters, level the oven by
screwing the adjustable feet in or out as nec-
essary.
6” (15 cm) Legs Shown
Figure 6