Blitz DUPLEX S2, Operating Instructions Manual

Page: 36 / 54

INSPECTION BOOK DUPLEX-S2
30
117127
● 07/2011
Master data sheet DUPLEX-S2 lift
Manufacturer Lift
BlitzRotary GmbH
Type ...............................................
Hüfinger Str. 55
78199 Bräunlingen
Serial number ................................................
Germany
Intended use

The lift is intended for lifting and lowering commercial vehicles for repair, maintenance and cleaning during
normal workshop operation.

The lift is only to be used as intended, in technically sound condition according to technical specifications
in chapter 3.2.

The maximum load capacity of one lifting cylinder is 15 000 kg and is not to be exceeded.

The permissible load distribution in or against drive direction is 2:1.

Standing or working under suspended load is permitted.

Misuse: Improper behavior can cause danger for life and health of persons working in the vicinity of the lift.
The manufacturer is not responsible for damages caused by use against regulations and misuse.
Standing and riding on load and pick-up equipment, standing or working under the suspended load during
lifting and lowering, lift installation in explosive areas and lifting of vehicles loaded with hazardous goods is
prohibited.

Supplied pick-up equipment (axle cross members) are not adjusted for specific vehicle types. They are
part of the basic configuration.

The lift must be inspected by authorized expert after design modifications or repair of load-bearing compo-
nents. This also applies after moving the equipment to a different installation location. Modifications are to
be carried out by competent person and are to be recorded in the set-up report.
Design modifications: Start-up inspection by competent person
Following modifications were carried out: .................................................................................................
...................................................................................................................................................................
...................................................................................................................................................................
.............................................. ............................................................ ...................................................
Date, place Name of authorized expert Signature of authorized expert
Change of installation location: Start-up inspection by competent person
Following modifications were carried out: .................................................................................................
...................................................................................................................................................................
...................................................................................................................................................................
.............................................. ............................................................ ...................................................
Date, place Name of authorized expert Signature of authorized expert