180-CL2714.SP v1.00
July 30, 2020
Page 14
Clarity CL2714 SP
OPERATING INSTRUCTIONS
PILOT LIGHT
Refer to the lighting instruction label on how
to light the pilot. Check that the pilot has
fully engulfed the thermocouple assembly
(
Fig.1
).
LIGHTING THE BURNER
Standing Pilot (SP)
The CLARITY CL2714 SP controls are
located behind the hinged flap beneath the
firebox.(
Fig.2
) To light the burner follow the
steps below:
1.
Make sure the pilot is lit (see “LIGHTING
INSTRUCTIONS Standing Pilot”)
2.
Turn the “
Valve Control
” knob
counterclockwise
to ON.
3.
Flip the flame ON/OFF switch, located
beside the igniter to ON.(
Fig.2
)
4.
Turn the “
Flame Height
” knob to the
desired flame height.(
Fig.2
)
5. Turn on all electrical power to the unit.
6. NOTE
: Burn the appliance on high, with
the optional blower OFF, for the first
two to three hours. This will cure all the
paint, gasket, and seals. It is advised to
open a door or window as the unit will
smoke and give off odors as it is curing.
OPTIONAL BLOWER
An optional blower S.Z4946.SP is available.
For installation refer to the installation
instructions provided with the kit.
Turn the blower on by turning the “
Blower
Speed
” knob clockwise
.(
Fig.2
) The
blower will only come on when the fireplace
is up to temperature (approximately 10-
15 minutes) because it is equipped with
a thermal switch. Fan speed control
sequence is off, then maximum to minimum.
The speed of the fan can be decreased by
turning the knob clockwise
. The speed
of the fan can be increased by turning the
knob counterclockwise
. The blower
will continue to operate after the burner is
turned off (approximately 15-20 minutes).
To turn the blower off manually, turn the fan
control knob counterclockwise
until it
“clicks”.
Fig.2
Fig.1
