www.blaubergventilatoren.de
Freshbox (E)/(E1)/(E2)-200 ErV WiFi
10
Remove the mounting template and drill two through holes
Ø 120 mm for round air ducts.
When mounting the unit with an extract spigot, prepare a hole in
the wall for a connecting bend and for laying of a rectangular air
duct.
A connecting bend, rectangular and round air ducts are available
separately.
Drill holes (Ø 8 mm, 90 mm deep) to mount the unit.
Install the expansion anchors, remove the perforated fillers for the
air ducts from the mounting template and install the mounting
template back.
Cut air ducts of required length. Note that the telescopic air duct
end must protrude for the distance that enables installation of
the outer ventilation hood (A). For details, refer to the installation
instruction for the ventilation hood.
The outer ventilation hood is available separately.
A
Insert the air ducts in the corresponding holes of the mounting
template.
Install the air duct with the minimum slope of 3 mm for condensate
removal.
To install the unit with an additional spigot insert the connecting
bend into the prepared hole in the wall, aligning the mounting
template hole with a round end of the connecting bend.
Connect a rectangular duct to the connecting bend.
Fill the gaps between the air ducts and the wall with a mounting
foam.
Wait till the mounting foam hardens then take off the mounting
template and remove the foam excess.
Cut off the protruding air duct parts to be flush with the wall
surface.
min 3 mm
To install an extract spigot, remove the plug on the rear part of
the unit.
Undo the screws, remove the plug and fix a spigot on its place
using screws.
Open the unit.
Undo the screws and remove the protective panel for accessing
the mounting holes.
