www.blaubergventilatoren.de
Freshbox (E)/(E1)/(E2)-200 ErV WiFi
16
Wi-Fi parameter setup
Go to the application menu on your mobile device
Menu (
)– Connection – Wi-Fi setup.
Then press
Receive
.
The screen will display the current Wi-Fi parameter settings. Select one of the Wi-Fi operation modes:
Access Point
or
Client
.
Access Point:
access point mode without a home router.
Up to 8 devices can be connected to the unit in this mode.
Select the desired security level for the
Access point
mode:
Open
means no password protection.
WPA PSK:
password-protected.
WPA2 PSK:
password-protected.
WPA/WPA2 PSK:
password-protected (recommended).
Enter your access point password.
Change the Wi-Fi channel if necessary.
Press the
APPLY
button.
Client:
the unit operates on the home router network.
Enter the home router details and the IP address type for the Client mode:
Enter the name of the Wi-Fi home router access point.
Enter the password for the Wi-Fi home router access point.
Select an IP address type:
DHCP
: the IP address is set up automatically upon connection to the home router (recommended).
Static:
enables manual entry of the desired IP address, subnet mask and default gateway.
These settings are recommended for expert users only.
Select this IP address type at your own risk.
Then press the
APPLY
button.
Special Setup mode
In the event of losing the Wi-Fi password or the unit password, connecting external devices or in other cases use the special Setup mode
to restore access to the unit functions.
To enter the special Setup mode, press and hold the Wi-Fi button on the control panel for 5 seconds before the LED on the button starts
flashing.
The unit will continue in this mode for 3 minutes and then will automatically revert to the previous settings.
To immediately exit the Setup mode, press and hold the button again for 5 seconds until the LED on the button stops flashing.
In this mode the following settings are available:
Wi-Fi name:
Setup mode.
Wi-Fi password:
11111111.
The unit password is ignored.
