Blata Minibike Elite 14 WRS, Service Manual

Page: 10 / 24

REMOVE AND REPLACE THE FRONT WHEEL - FIG. 5
Before dismantling the front wheel it is necessary to remove the front brake
pads from the front brake, so it is possible to move the brake caliper from the
wheel and be able to draw out the wheel and tire. Remove the front axel nut.
M10 (920.011.01) Draw out the axel from the fork and wheel. Remove the wheel
by an easy pull downwards from the forks. Caution, while removing the wheel
the left side spacer washer will fall out! During the assembly process put the
spacer washer between the brake rotor and brake caliper mount plate and the
right side distance spacer between the wheel and right fork (315.011.00).
Return the brake pads with the spring and tighten up the axel nut. Perform the
basic brake adjusting. Double check your work. This is important!
REMOVE AND REPLACE THE REAR WHEEL - FIG. 5
Remove the rear wheel axel nut. Loosen the nut on the rear caliper anchor
plate. Remove the two wheel adjustor plate nuts. (M6) Move the wheel forward
and remove the chain. Safely (hold) keep the rear wheel from falling out while
pulling out the axel. Caution, note the location of both spacer tubes and one
spacer washer (between caliper mount plate and rotor) while removing wheel.
When refitting the wheel, make sure to slide the brake rotor into the caliper
between the pads. Hold the wheel in place and fit the wheel spacers in proper
order. Insert the spacer washer between the caliper plate and the brake rotor
and on the both sides place the axel spacers at the appropiate time during
assembly. Adjust chain tension and tighten axel nut. Tighten the caliper
holder plate nut and set and tighten both chain adjustor plate M6 nuts. At this
time check the brake operation. Recheck all your work. This is important!
REPLACEMENT OF PINION - FIG. 9
First dismantle the front chain guard and chain guard.Loosen the nut of rear
wheel axle and the nut of chain tightener ,remove chain. Insert carefully a
larger screw drive or steel rod into the hole of clutch drum, Fig. 9, to avoid a
turning over the clutch drum at releasing the pinion. Using the pinion wrench
P/ N 319.050.00, release the new pinion to be carried out by reverse way.
FIG. 9
7