Blata Minibike Elite 14 WRS, Service Manual

Page: 9 / 24

ADJUSTING THE BRAKES
Small incremental brake adjustment
Free play at the handlebar lever is effected by turning the knurled end on the
cable adjustor. This will allow the lever to be set at the nominal to ¼ inch of
free lever movement.
Basic brake adjusting:
Screw in the knurled cable adjustor at the brake lever so the cable is in it’s
most slack starting position.. At the caliper, loosen the nut, No. 3 and tighten
the adjustable bolt No. 4, so the wheel cannot turn. Back off bolt No. 4 about ¼
to ½ of a turn and fix it with lock nut No. 3. Do not use the cable retainer No. 5
for adjusting the brakes!
FIG. 4
FRONT BRAKE PADS REPLACEMENT - FIG. 7
First screw in the knurled cable adjustor at the right brake lever (122.002.00) on
the handlebars to the starting position (slackened cabled). Loosen the nut
(332.020.00) and turn the adjustable bolt (916.065.02) in the way that by
pressing the front brake lever, the lever (312.017.00) will be over the bolt head
M5 (312.018.00), which protects brake pads and spring of pads (312.020.00).
Unbolt this bolt and replace the old brake pads with new ones. When mounting
the brake pads place the brake spring against both pads, so they are pressed
into the front direction. While replacing the brake pads do not loosen bolts M5
(914.001.01) on the driving pins and do not loosen the cable retainer!
REAR BRAKE PADS REPLACEMENT - FIG. 7
First screw in the knurled cable adjustor at the left brake lever (122.001.00) on
the handlebars to the starting position (slackended cable). Loosen the nut
(332.020.00) and turn the adjustable bolt (916.065.02) all the way out. Unbolt the
nut M10 (920.011.01) of the back axel, push it out and dismantle the rear wheel
from the Swingarm. Push out the brake from driving pins, that will loosen the
brake pads and replace the old ones at this time. While replacing the brake
pads do not loosen bolts M5 (914.001.01) on the driving pins and do not loosen
the cable retainer! During the mounting follow all these instructions in the
reverse direction and then perform basic adjusting of the brakes.
6
4
3
5