Blastrac BS 180, Instruction Manual

Page: 17 / 60

Page 16
BS180 ANGLE ATTACHMENTS
The Angle Attachments angles the cutting head and blade or carbide shank to where the material comes
up the easiest. Lower is usually the best.
MOUNTING ANGLE ATTACHMENT
06-7280-2B Standard Angle
Attachment - 22 degree
06-7280-2C Steep Angle
Attachment - 30 degree
WARNING: Failure to block up the machine could cause
damage to the machine or cause serious injury.
•
Insert desired cutting head or carbide shank into
the angle attachment.
•
Secure with Retainer Cap (See Figure B).
•
Disconnect machine from power source.
•
Tilt machine back.
•
Securely block machine up (See Figure A).
•
Mount angle attachment onto the cutting head
support (See Figure C).
•
Securely tighten all five mounting bolts.
NOTE: Cutting head or carbide shank should freely swivel in
the angle attachment. This movement allows the
blade to stay in contact with the floor. Grease may
need to be applied to the shaft of the attachment
before inserting.
Figure A
Figure B
Figure C
22°
30°
Block