16
For machines with speed regulation:
5.3
Switching the machine on
Turn on the dust collector before switching on the
machine and connect the dust hose to the machine.
Make sure the electric component box is closed
Connect the power supply to the connector (1)
Turn the main switch to the right.
Stand behind the machine and hold the handle tight.
Put the cord of the deadman switch (2) on to your arm
or put it on to your clothing.
Check the display (3) to make sure there are not any
faults or warnings.
Be sure that the emergency switch (4) is turned up.
Turn the speed regulation button (5) counter clockwise
so the machine will turn as slow as possible.
Turn the Left/Right button (6) to one of the positions.
To start the machine, push the green Start button (7).
Raise if necessary the speed of the machine with the
speed regulation button (5)
5.4
Turning the machine off
Push the red (emergency) button (4) on the electrical
box.
Wait until the machine stops rotating.
Pull out the cord of the deadman switch (2)
Turn the main switch (2) to the left
Pull the power supply out of the connector (1)
Shut down the dust collector.
5.5
Operating during grinding
This machine will always have an even grinding result because of the planetary system.
However it is advised to keep the machine constantly in movement for an optimum grinding result.
For soft floors it is recommended to work on high disc speed, for hard floors and the first steps of polishing it is
recommended to grind with low speed of the tools.
In case of emergency or operating trouble, like vibrations or strong noises, switch the machine off
immediately!
Contact our experts at Blastrac for the correct application of the different tools
and their corresponding working speeds.
