11
A-QAMOS-4CI
Part N
o
: 5102.81
SAT-TV Transmodulator
DVB-S/ -S2 (8x QPSK/ 8PSK)
→
4x CI
→
DVB-C (8x QAM)
A
LINE
7.3.2 Menu ”SAT selection”
In this menu you can make the choice of the satellites and the input configuration of the device. In the left part of the user interface
there is the configuration menu of the input part.
The setting screen is divided into two sections “LNB Control“ and “Program tables for“, for the two satellite jacks 1 (IN) and 2 (IN/
OUT). The parameters of both sections can be adjusted separately with the “send“ button below and then transferred.
If the second sat jack (IN/ OUT) is configured as a loop-through output, or not used, then the input configuration parameters of the
LNB control and program table are grayed out and not adjustable.
selection of sat jack 1 (IN) and 2 (IN/ OUT)
Mode
1
selection: not used, input, output
LNB control
selection: on, off (remote supply off completely),
unicable
DiSEqC
selection: on, off
Satellite
2
selection: A, B, C, D
Tonburst
selection: off, A, B
22 kHz
selection: on, off
Voltage
selection: 13 V, 18 V
1
only for sat jack 2 (IN/ OUT) adjustable
2
only adjustable, if DiSEqC is on
Satellite
selection: Astra 19,2° East, Eutelsat 13° East,
Eurobird 9° East
Band
selection: Low, High
Polarization
selection: vertical, horizontal
In the selection field “LNB control“ the item “unicable“ is available for both satellite ports. Thus, it is possible that before the respective
satellite input a unicable module can be switched on then the transponder selection can be made according to the receiving equip-
ment installed there. So it is possible, to assign up to 8 satellites levels (one or more satellites) to the unicable module. From this
assigned levels the required transponders can then be selected and assigned.
