Blade Blade 350 QX2 AP Combo, Instruction Manual

Page: 13 / 18

13 EN
Return Home
• When this feature is activated, the 350 QX2
AP will fl y back to its assigned home location
and land. After landing, the motors may take
up to 5 seconds to disarm. If the motors take
more than 20+ seconds to disarm, perform
the Pressure Sensor Calibration.
• To restart the props after landing in Return Home,
fully lower the throttle, then quickly move the rudder
stick fully left and then fully right.
CAUTION: The 350 QX2 AP will not recognize
the SAFE Circle feature when Return Home
is used. Activating Return Home may cause the 350
QX2 AP to fl y directly over the pilot if the aircraft was
fl own to a position behind where the pilot was stand-
ing when the home position was established.
Activating Return Home
Switch to position 1.
Returning the switch to position 0
will stop the
Return Home program.
Landing
To land the 350 QX2 AP there are two options:
• Guide the aircraft to where you wish to land and re-
duce the throttle. Hold the bind button for 1 second
after landing to disarm the motors.
• Activate the Return Home function to return the
350 QX2 AP to the assigned home location and land
automatically.
CAUTION: Do not activate the Return Home
function if the 350 QX2 AP is showing the low
battery indication. Manually land the aircraft
immediately.
After Your Flight
1. Turn off the power switch on the 350 QX2 AP.
2. Turn off the power to your transmitter.
3. Unplug and remove the battery from the 350 QX2 AP.
CAUTION: Always disconnect the Li-Po bat-
tery from the aircraft when not fl ying to avoid
over-discharging the battery. Batteries discharged to a
voltage below the lowest approved voltage may become
damaged, resulting in loss of performance and potential
fi re when batteries are charged.
Location alert
The motors will beep under the following conditions:
• At any time the props stop spinning after they have
been initialized.
• After 30 seconds of no throttle input (waiting armed
on the ground).
This will alert the pilot to the location of the aircraft if it
lands in a location with low visibility.
Beeping will continue until the battery can no longer
supply enough power to the motors.
If the quadcopter crash lands and one or more motors
are stopped by an impact, the quadcopter enters
emergency mode. The LED will fl ash white and the
motors will beep loudly.