Blackmagicdesign Blackmagic MultiView 4, Installation And Operation Manual

Page: 70 / 343

1 3
↵
…
↵
The next block describes the locking status of the views. Each port has a lock status of
“
O
”
for ports
that are owned by the current client (i.e., locked from the same IP address),
“
L
”
for ports that are
locked from a different client, or
“
U
”
for unlocked.
VIDEO OUTPUT LOCKS:
↵
0 U
↵
1 U
↵
…
↵
The last block is the configuration block.
Layout: SOLO or 2x2 or 3x3 or 4x4
Output format: 50i or 50p or 60i or 60p
Solo enabled: True or False
Widescreen SD enable: True or False
Display border: True or False
Display labels: True or False
Display audio meters: True or False
Display SDI tally: True or False
Status Updates
When any route, label, or lock is changed on the multi view by any client, the multi view resends the
applicable status block, containing only the items that have changed.
If multiple items are changed, multiple items may be present in the update:
OUTPUT LABELS:
↵
7 New output 8 label
↵
10 New output 11 label
↵
↵
Requesting Changes
To update a label, lock or route, the client should send a block of the same form the multi view sends
when its status changes. For example, to change the route of output port 8 to input port 3, the client
should send the following block:
VIDEO OUTPUT ROUTING:
↵
7 2
↵
↵
The block must be terminated by a blank line. On receipt of a blank line, the multi view will either
acknowledge the request by responding:
ACK
↵
↵
or indicate that the request was not understood by responding:
NAK
↵
↵
After a positive response, the client should expect to see a status update from the MultiView showing
the status change. This is likely to be the same as the command that was sent, but if the request
could not be performed, or other changes were made simultaneously by other clients, there may be
more updates in the block, or more blocks. Simultaneous updates could cancel each other out,
leading to a response that is different to that expected.
For MultiView 16 the client can change the solo source and the audio source to embed on the output.
Solo mode needs to be enabled either from the front panel or by sending the block:
70 70 Developer Information