USB560v2-IG-01
XBlackhawk USB560v2 System Trace Emulator
11
2.3.1.1 USB
Connector
The BH560v2 emulator has a USB mini-A/B connector (see Figure 2)
The connector serves two purposes.
Host interface used for communications
Power for the BH560v2 pod
The USB connector can be utilize for both purposes at the same time. In other words, you can
power the BH560v2 using the USB connector and also use it at the same time for debug. For
more information on powering the BH560v2 via the Universal Serial Bus, please refer to section
2.7,
Power Options
.
2.3.1.2 JTAG Cable Connector
The JTAG cable connector is show in Figure 2 and Figure 6. It comes pre-connected to the
emulator pod
WARNING:
The BH560v2 does not require an additional buffer board and cannot be used with a
buffer board; only use MIPI60 pin converters.
2.4 Target Interface Cable
In the BH560v2 System Trace Emulator kit, you will find that the Coax JTAG cable is pre-
connected to the emulator pod and uses a standard MIPI60 connector.
190mm
29mm
Figure 6 - Target Interface Cable (top view)
8mm
Figure 7 - Target Interface Cable drawing (side view)
2.4.1.1 Target Signal Buffer Board
The BH560v2 kit does not contain an active buffer board. Do not use the BH560v2 with a buffer
board.
Only use MIPI60 pin converters.