I N S T A L L I N G T H E C A D E N C E T R A N S M I T T E R A N D B R A C K E T
I N S T A L L I N G T H E C O M P U T E R O N Y O U R B I K E
I N S T A L L I N G T H E C O M P U T E R O N Y O U R B I K E
ENGLISH
ENGLISH
C Y C L E C O M P U T E R
1 6
I N S T A L L I N G T H E C A D E N C E T R A N S M I T T E R A N D B R A C K E T
Activation of the cadence functions of the Delphi 4.0, 5.0 and 6.0 units requires the installation of the
bracket with the wired cadence sensor.
1. Attach the cadence sensor to the LEFT chain stay near where the crank/pedal pass the stay using the
zip-ties provided. Snug up the zip-ties but do not fully tighten them. It is recommended the cadence
sensor be mounted on the top of the chainstay.
NOTE:
The wire exiting the sensor should be pointing toward the front of the bike.
2. Attach the cadence magnet to the back side of the LEFT crank arm using the zip-tie provided. The
cadence magnet should be attached as closely to the pedal spindle as possible.
3. Adjust and position the sensor so the magnet passes within 1-3mm. Fully tighten the zip-ties once
you have everything properly aligned.
4. Route the sensor wire forward and under the bottom bracket and along the bottom of the down tube
securing it occasionally with tape. Once you are near the head tube, the sensor wire should be
wrapped around the front or rear derailleur cable housing and the front brake cable housing.
5. Attach the bracket to the handlebars and tighten the mounting screw.
CAUTION
—Make sure you leave enough slack in the sensor wire so the handle bars can turn fully from side to
side without creating any stress.
1 5
Blackburn_4/5/6_Manual 8/3/05 9:58 AM Page 18
