P R O G R A M O D O M E T E R S
P R O G R A M T I M E O F D A Y
ENGLISH
ENGLISH
Blackburn Delphi Computers are equipped with Separate Odometers for Bike 1 and
Bike 2 and a Combined Odometer showing the total for both bikes. Bike 1 and Bike
2 Odometers may be reprogrammed with an existing mileage following a battery
change.
NOTE:
Make sure you write down your mileage for each Odometer prior to removing
the battery if you wish to reprogram the odometers.
NOTE:
If Odometer 1 and Odometer 2 are set for different units (Miles or Kilometers)
as defined by the Speed and Distance Units settings for Bike 1 and Bike 2,
the Combined Odometer (ODO 1/2) will display in the units set for Bike 1.
NOTE:
If the total capacity of any odometer is exceeded, the Lower Data Window will
display 5-dashes.
S T E P B Y S T E P — S E T T I N G T H E P R O G R A M M A B L E
O D O M E T E R S
1. Starting in ANY Odometer screen (Odo 1, Odo 2 or Odo 1/2 ) in either Bike 1
or Bike 2.
2.
PRESS & HOLD
the MODE key for approximately 2-seconds.
3. ODO 1 will appear in the Lower Data Window with "00,000" in the Center
Display Line.
4. Adjust the Odometer 1 setting using
QUICK PRESSES
of the OPTION and
START/STOP keys. Fast advance using a
PRESS & HOLD
.
5. When Odo 1 is set to the desired value,
QUICK PRESS
the MODE key to enter
the value and Advance to setting Odo 2.
6. Repeat steps 3 and 4.
7.
QUICK PRESS
the MODE key to enter the Odo 2 value and exit the setting
sequence.
S T E P S 3 & 4
S T E P S 5 & 7
3 7
Blackburn Delphi Computers are equipped with a clock which shows time of day in either 12 or 24 hour
formats. There is also a programming option which allows you to turn the clock off so it does not show up in
the normal operation sequence, reducing the number of key strokes needed to move through the displays.
S T E P B Y S T E P — S E T T I N G T H E T I M E O F D A Y
1. Starting in the Time of Day display in the Lower Data Window if Time of Day is Active; or Starting in
the Average or Maximum Speed displays if Time of Day is Inactive.
2.
PRESS & HOLD
the MODE key for approximately 2-seconds.
3. VIEW will appear in the Lower Data Window with ON or OFF in the Center Display Line.
4. Select ON or OFF using
QUICK PRESSES
of the OPTION key.
QUICK PRESS
the MODE key to enter the
value and advance to 12/24 Hour setting.
a. Select ON if you wish Time of Day to be part of the display sequence in the Lower Display Window.
b. Select OFF if you do not wish to view Time of Day on the display.
5. Repeat steps 3 and 4 to Set Hours and Minutes and
QUICK PRESS
the MODE key to exit the Time of
Day programming sequence.
NOTE:
Before you can program any computer settings, the primary chronograph must be cleared to zero
using a 2-second
PRESS & HOLD
of the S/S key while in the Ride Distance (DST) screen.
3 8
C Y C L E C O M P U T E R
Blackburn_4/5/6_Manual 8/3/05 9:58 AM Page 40
