18
LDM-MR19.2
3. Standalone Installation
Follow the directions in this chapter to install the standalone version of the
LDM-MR19.2. Once you’ve done this, see
Chapter 5
for operating information.
3.1 Complete Package
With your LDM-MR19.2 order, you should have received (1) LDM-MR19.2,
(1) detachable 5-ft. (1.5-m) AC power cord, and (1) copy of this manual. The
LDM-MR19.2 is fully assembled at the factory. You don’t have to assemble any
part of the unit. However, you will have to attach an appropriate plug to the
power cord if your unit is a 230-VAC (ME760AE-R2) model.
3.2 Physical Placement
Place the LDM-MR19.2 on a tabletop or bench within 5 feet (1.5 m) of a grounded
3-wire AC outlet and within 50 feet (15.2 m) of the associated data terminal. The
unit is not designed to be bolted down.
Allow at least 36 inches (90 cm) of clearance in front of the unit so you can
operate and maintain it. Be sure to leave 4 inches (10 cm) of clearance behind
the unit for signal lines and interface cables.
3.3 Data Cables
The LDM-MR19.2’s data-communication connectors (a five-crimp terminal
block and a DB25 connector) are on its rear panel (see
Figure 3-1
below).
Figure 3-1. The LBM-MR19.2’s rear panel (ME760A-R2 model shown).
DTE
XMT
RCV
GND
115 VAC/
- 0.2A T 250V
J1
TB1
