31
CHAPTER 4: Card Installation
4.4 Card-Configuration Procedure
Before putting the LDM-19.2 card in the RackNest 2/14 or attaching anything to
the Card, determine which data rate you’re going to use and how you want to set
all of the other user-configurable options on the Card. (Refer to Table 4-2 on the
next two pages for a list of all of these options; the SW
n
and J
n
numbers in the
table’s “Element” column correspond to the locations with the same numbers in
Figure 4-1 on page 36.)
When you have everything at least tentatively decided, identify the control(s)
on the Card whose settings you want to change (refer to Figure 4-1), then move
the control(s) to your desired position(s).
CAUTION!
Make sure the Card is disconnected from the RackNest 2/14 and from all
sources of electric power.
WARNING: HIGH VOLTAGE!
Any adjustment, maintenance, and repair of the Card under voltage
should be avoided as much as possible, and, when inevitable, should be
carried out only by a skilled person who is aware of the hazard involved.
Capacitors on the Card may still be charged even after the Card has
been disconnected from the power source.
