PROBABLE
SUGGESTED
SYMPTOM
CAUSE
CORRECTION
Keyless will not go
RED or YELLOW wire not connected
RED wire should connect directly to
into Code Learning
to the correct power source. Code
the battery. Connect YELLOW wire to
Mode
Learning sequence done to slow.
true ignition wire (Not at Fuse Block).
Redo Code Learning sequence faster.
Remote Control does
Defective Remote Control. Bad
Replace Remote Control or its
not lock and unlock
battery. Antenna wire is
battery. Unground antenna.
the vehicle.
grounded.
Override does not work.
Bad switch or switch is not pressed
Repair or replace switch or check
long enough to activate the Keyless
ignition wire for voltage.
Entry
Flashing output does
Bad connection on WHITE
Check WHITE wire. Connect
not work.
wire or the drive polarity is
a SPDT Relay to this wire and
wrong for the circuit being
apply the opposite polarity to the
driven.
circuit being driven.
Door locks do not
Defective GREEN or BLUE
Check GREEN and BLUE wires
lock/unlock correctly,
wire from door lock connector plug,
on door lock connector plug.
or action is reversed.
GREEN and BLUE wires on door lock
Check vehicle’s door lock
connector plug reversed, or wrong
system for method of operation.
door lock wiring diagram used.
Reverse wiring to door relays.
752/1/L Re
v.7 091997
