-
2
-
11.
Connect the Main 6-Pin Wiring Harness and all pin connectors to the Control Module. Install the fuse
in the RED wire of the main wiring harness.
13.
Code Learning Procedure:
To add a new remote to the system, turn ignition key ON, OFF, ON, OFF, and leave on (3 times). Siren/Horn
will chirp once. Press override/valet switch for 5 seconds, you will hear 3 chirps. You now have 5 seconds to press
the arm buttons on the remotes that you want to operate the system. It will hold 3 different codes in memory
and will erase all previous codes. You will get a confirming chirp after it has learned each new remote.
14.
Test Starter Disable Feature by:
A. Pressing button#1, LED will flash slowly and Starter Disable will be activated.You should not be able to
start the engine while the Starter Disable is engaged. Once all testing is complete, secure all loose wiring and/or
components and reassemble the vehicle.
15.
To activate Override Feature with Starter Disable activated, turn the ignition switch ON, press over-
ride switch for 5 seconds, the LED will turn ON solid. Start your vehicle in normal operation.
16 .
The Status Indicators below, show the various signals that are produced to indicate a particular condition
or situation of the Starter Disable/Keyless Entry System:
17.
Siren/Horn Pulsing Output
To enable pulsing horn output,
with the ignition key ON, push button #3 on 3 button remote (push buttons #1 and
#2 simultaneously on 2 button remote), LED will flash twice. Pulsing horn output is activated.
Disable horn output– Enables siren output, with the ignition key ON, push button #3 on 3 button remote (push
buttons #1 and #2 simultaneously on 2 button remote), LED will flash once. Steady siren/horn output is activated.
18.
Current Sensing Loop. Cut the Brown loop (current sensing is disabled from the factory).When the door is
opened, if the dome light is ON and the light bulb is strong enough, it will sense current and trigger the alarm.
PARKING LIGHTS STATUS
LED STATUS
A)1 Flash = Starter Disable ON/Door lock
A) No Flash = Starter Disable OFF/Unlocked vehicle
B) 2 Flashes = Starter Disable OFF/Door unlock
B) Steady Flash = Starter Disable ON/Doors locked
C) 30 sec. Flashing Lights= Starter Disable OFF
C) Rapid Flash= Passive prearm mode
or vehicle unlocked
D) Solid = Valet Mode
