JU87 - STUKA
.
Item code: BH80A.
Instruction Manual
6
Repeat the procedure to install the second aileron
linkages in the opposite wing half
.
After both linkages are completed. connect both of
the aileron servo loads using a Y-harness you have
purchased.
II. INSTALLING THE FLAP
Flaslink
Pushrod wire Control horn
III. MAIN GEAR INSTALATION
PLASTIC FAIRING FOR LANDING GEAR.
Secure the gear to the wing.
Install the wheel pants.
Flap install as same as the way of aileron. Repeat
step #1 - #3 on the part
I
to install the flap.
5x35mm
Collar
4x15 mm
Secure
Using a modeling knife, carefully remove the film cov
-
ering from the gear slots at the wing. Make sure that
you do not remove any wood from the slots.
3x12mm
Drill a hole 2.5mm
and secure
Bottom side.
