JU87 - STUKA
.
Item code: BH80A.
Instruction Manual
13
2. ELEVATOR PUSHROD INSTALLATION
1)
Using pliers, carefully make a 90 degree bend
down at the mark made. Cut off the excess wire, leaving
about 6mm beyond the blend.
2)
Insert the 90 degree bend down through the
hole in the servo arm. Install one nylon snap keeper
over the wire to secure it to the arm. Install the servo
arm retaining screw.
VIII. THE TAIL WHEEL BRACKET,
RUDDER INSTALLATION
Rudder install as same as the way of elevator.
M2 Lock nut
M2
Elevator pushrod
Bottom side.
Silicone Tube
Cut.
Bend
Secure.
Elevator pushrod
Secure.
Flaslink
Pushrod wire
servo arm
Snap keeper
Elevator servo
1. RUDDER CONTROL HORN INSTALLATION
Rudder control horn install as same as method of
elevator control horn.
Push in
Rudder pushrod
Rudder
control horn
M2 Lock nut
M2
2. Push in
1. A+B Epoxy glue
Control horn