JU87 - STUKA
.
Item code: BH80A.
Instruction Manual
5
3)
Place the servo into the servo tray. Center
the servo within the tray and drill 1.5mm pilot holes
through the block of wood for each of the four mount-
ing screws provided with the servo.
Drill a hole
1.5mm
2x10mm
Secure
5)
Repeat the procedure to install the aileron servos
in the opposite wing half.
2. INSTALLING THE AILERON CONTROL HORN
1)
Remove the covering from the slot on the bot-
tom of the aileron.
2)
Insert the control horn into the slot and secure
it by A+B Epoxy glue.
4)
Using the thread as a guide and using
masking tape, tape the servo lead to the end of the
thread: carefully pull the thread out. When you have
pulled the servo lead out, remove the masking tape and
the servo lead from the thread.
Secure
Electric wire
Electric wire
1. A+B Epoxy glue
2. Push in
Aileron
control horn
3. INSTALLING THE AILERON LINKAGES
Installing the aileron linkages as pictures below.
180mm
Snap keeper.
M2
lock nut
Using pliers, carefully make a 90 degree bend down at
the mark made. Cut off the excess wire, leaving about
6mm beyond the blend.
Insert the 90 degree bend down through the hole in the
control horn. Install one nylon snap keeper over the
wire to secure it to the control horn. Install the control
horn retaining screw and remove the masking tape
from the aileron.
3) Repeat the procedure to install the control horn
on the opposite aileron.
Bend and cut.
Silicone Tube
