THUNDERBIRDS Item code: BH144-A
.
Instruction Manual
4
1. INSTALLING THE AILERONS
I. AILERON
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
Temporary pin to
keep hinge centered.
Test t the ailerons to the wing with the hinges. If the
hinges don’t remain centered, stick a pin through the
middle of the hinge to hold it in position.
See pictures below:
2. INSTALLING THE AILERON SERVOS
1
1)
Install the rubber grommets and brass
eyelets on to the aileron servos.
1
2 )
U s i n g a m o d e l i n g k n i f e , r e m o v e t h e
covering from over the pre-cut servo arm exit hole on
the aileron servo tray / hatch. This hole will allow the
servo arm to pass through when installing the aileron
pushrods.
Servo tray
Remove the covering
REPLACEMENT SMALL PARTS
Bottom side.
2x10mm
5x30mm
3x12mm
3x15mm
3x4mm
