THUNDERBIRDS Item code: BH144-A
.
Instruction Manual
5
1
4)
Place the servo into the servo tray. Center
the servo within the tray and drill 1.5mm pilot holes
through the block of wood for each of the four mount-
ing screws provided with the servo.
Drill a hole
1.5mm
2x10mm
Secure
1
5)
Repeat the procedure to install the aileron servos
in the opposite wing half.
1
1)
Remove the covering from the slot on the bot-
tom of the aileron.
1
2)
Insert the control horn into the slot and secure
it by A+B Epoxy glue.
1
3)
Using the thread as a guide and using
masking tape, tape the servo lead to the end of the
thread: carefully pull the thread out. When you have
pulled the servo lead out, remove the masking tape and
the servo lead from the thread.
Drill a hole
1.5mm
Secure
Electric wire
Electric wire
1. A+B Epoxy glue
2. Push in
Aileron
control horn
4. INSTALLING THE AILERON LINKAGES
Installing the aileron linkages as pictures below.
100mm
Snap keeper.
M2
lock nut
Using pliers, carefully make a 90 degree bend down at
the mark made. Cut off the excess wire, leaving about
6mm beyond the blend.
1
3) Repeat the procedure to install the control horn
on the opposite aileron.
