THUNDERBIRDS Item code: BH144-A
.
Instruction Manual
11
Battery of EDF
ESC
UBEC
Battery of
receiver
Locate the aluminium wing dihedral brace.
XI. WING ATTACHMENT
512mm
Aluminium tube.
12mm.
*** Test t the aluminium tube dihedral brace into each
wing haft. The brace should slide in easily. If not, use
220 grit sand around the edges and ends of the brace
until it ts properly.
Attach the aluminium tube into the fuselage.
Bottom side.
Receiver
Insert the wing panel as pictures below.
Screw the wing panel in position.
Push in
Push in
Bottom side.
Push in
Bottom side.
Secure
Open
and close
1
2)
Wrap the receiver and battery pack in the
protective foam to protect them from vibration.
Use a rubber band or masking tape to hold the
foam in place.
1
3)
Position the battery pack and receiver is as
picture below.
Do not permanently secure the receiver and battery
until after balancing the model.
1
4)
Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for the
antenna to exit.
Bottom side.
Open
and close
