TWISTER
.
Instruction Manual
4
4. Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
Electric wire
3. Drill 1,5mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo. Install servo into ai-
leron servo tray as same as picture below.
Aileron servo tray
INSTALLING THE AILERON SERVOS.
1. Install the rubber grommets and brass
eyelets onto the aileron servo.
2. Using a modeling knife, remove the cov-
ering servo tray.
Bottom side of the wing.
Servo tray.
