TWISTER
.
Instruction Manual
18
Rudder control horn install as same as the
way of aileron control horn. Please see pic-
tures below.
Control horn of Rudder.
RUDDER CONTROL HORN INSTALLA-
TION.
3mm x 40mm.
M3 lock nut
.
Nilon
control clasp.
Mark point
Remove
covering
Epoxy glue
C/A glue
6) When you are sure that everything is a
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
slot in the mounting platform and to the vertical
stabilizer mounting area. Apply epoxy to the
lower rudder hinge. Set the stabilizer in place
and re-align. Double check all of your
measurements once more before the epoxy
cures. Remove any excess epoxy using a
paper towel and rubbing alcohol and hold the
stabilizer in place with T-pins or masking tape.
Allow the epoxy to fully cure before proceeding.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
