TWISTER
.
Instruction Manual
14
5) When you are sure that everything is
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
top and bottom of the stabilizer mounting area
and to the stabilizer mounting platform sides
in the fuselage. Slide the stabilizer in place and
re-align. Double check all of your
measurements one more time before the
epoxy cures. Remove any excess epoxy using
a paper towel and rubbing alcohol and hold
the stabilizer in place with T-pins or masking
tape.
Epoxy glue
Top side
Bottom side
3) Mark the shape of the vertical on the
left and right sides onto the horizontal stabi-
lizer using a felt-tip pen
4) Remove the stabilizer. Using the lines
you just drew as a guide, carefully remove the
covering from between them using a modeling
knife.
When cutting through the covering to remove
it, cut with only enough pressure to only cut
through the covering it’s self. Cutting into the
balsa structure may weaken it. This could lead
to possible failure during flight
Mark point
Top side
Bottom side
