B.A.Eagle
.
Item code: BH158.
Instruction Manual
10
B
B
A
A
3)
Check the fit of the horizontal stabilizer in its
slot. Make sure the horizontal stabilizer is square and
centered to the fuselage by taking measurements, but
don’t glue anything yet.
VII. INSTALLING HORIZONTAL
STABILIZER
2)
Draw a center line onto the horizontal stabilizer.
Then put the horizontal into the fuselage.
Trim the covering
from the tail slots.
Center line
1)
Using a modeling knife, carefully remove the film
covering from the tail slots at the rear of the fuselage.
Make sure that you do not remove any wood from the
slots as this will affect the alignment of the tail.
Top side.
5)
Elevator install as same as the way of aileron
.
Please see pictures below.
4)
With the horizontal stabilizer correctly aligned.
Apply a thin CA layer to the top and bottom of the sta-
bilizer in the fuselage.
C/A glue.
Top side.
Top side.
Check to mark sure the wing and stabilizer are
paralell. If they are not, lightly sand the opening
in the fuselage for the stabilizer until the stabilizer
is paralell to the wing, but don’t glue anything yet.
A
A
A = A
