B.A.Eagle
.
Item code: BH158.
Instruction Manual
11
1. ELEVATOR CONTROL HORN
INSTALLATION
Elevator control horn install as same as the way of
aileron control horn.
Please see pictures below.
Please see pictures below.
M2 Lock nut
M2
Elevator pushrod
Silicone Tube
Bottom side.
control horn
1.A+B Epoxy glue
2. Push in
Drill a hole
1.5 mm
2. ELEVATOR PUSHROD INSTALLATION
1)
Using pliers, carefully make a 90 degree bend
down at the mark made. Cut off the excess wire, leaving
about 6mm beyond the blend.
2)
Insert the 90 degree bend down through the
hole in the servo arm. Install one nylon snap keeper
over the wire to secure it to the arm. Install the servo
arm retaining screw.
Cut.
Bend
Secure.
Elevator pushrod
Flaslink
Pushrod wire
servo arm
Secure.
Elevator servo
Snap keeper
VIII. THE TAIL WHEEL BRACKET,
RUDDER INSTALLATION
Secure the tail wheel bracket in place using three 3mm
x 12mm wood screws. Be careful not to overtighten the
screws.
3 x 12mm
