B.A.Eagle
.
Item code: BH158.
Instruction Manual
8
Locate the long piece of wire used for the throttle
pushrod. One end of the wire has been pre-bend in to a
“Z” bend at the factory. This “Z” bend should be inserted
into the throttle arm of the engine when the engine is
fitted onto the engine mount. Fit the engine to the engine
mount using the screws provided.
OPTION 2: ENGINE MOUNT
4x30mm
125mm
1. INSTALLING THE STOPPER ASSEMBLY
1)
The stopper has been pre-assembled at the
factory.
2)
Using a modeling knife, cut one length of silicon
fuel line (the length of silicon fuel line is calculated by
how the weighted clunk should rest about 8mm away
from the rear of the tank and move freely inside the
tank). Connect one end of the line to the weighted
clunk and the other end to the nylon pick up tube in
the stopper.
3)
Carefully bend the second nylon tube up at a 45
degree angle (using a cigarette lighter). This tube will
be the vent tube to the muffler.
4)
Carefully bend the third nylon tube down at a 45
degree angle (using a cigarette lighter). This tube will
be vent tube to the fueling valve.
When the stopper assembly is installed in the tank, the
top of the vent tube should rest just below the top sur-
face of the tank. It should not touch the top of the tank.
V. FUEL TANK,
SERVOS INSTALLATION
To carburetor
fuel inlet
Atter confirming the direction
(see front view of fuel tank). Insert and tighten the screw.
Be sure to equip
air vent pipe.
Tubing for
re-fuelling
Not included.
Tygon tubing (Gas). And
silicone tubing (Methanol).
5mm
5)
Test fit the stopper assembly into the tank. It may
be necessary to remove some of the flashing around
the tank opening using a modeling knife. If flashing is
present, make sure none of it falls into the tank.
6)
When satisfied with the alignment of the stopper
assembly tighten the 3mm x 20mm machine screw until
the rubber stopper expands and seals the tank opening.
Do not over tighten the assembly as this could cause
the tank to split.
7)
Using a modeling knife, cut 3 lengths of fuel line
150mm long. Connect 2 lines to the 2 vent tubes and 1
line to the fuel pickup tube in the stopper.
8)
Feed three lines through the fuel tank compart-
ment and through the pre-drilled hole in the firewall. Pull
the lines out from behind the engine, while guiding the
fuel tank into place. Push the fuel tank as far forward as
possible, the front of the tank should just about touch
the back of the firewall.
Blow through one of the lines to ensure the fuel
lines have not become kinked inside the fuel tank
compartment. Air should flow through easily.
9)
To secure the fuel tank in place, apply a bead of
silicon sealer to the forward area of the tank, where it
exits the fuselage behind the engine mounting box and
to the rear of the tank at the forward bulkhead.
Do not secure the tank into place permanently until after
balancing the airplane. You may need to remove the
tank to mount the battery in the fuel tank compartment.
Fuel tank
Tie wrap
See pictures below:
