B.A.Eagle
.
Item code: BH158.
Instruction Manual
6
II. INSTALLING THE FLAP
Flap install as same as the way of aileron. Repeat
step #1 - #4 on the part I
(page 4,5)
to install the flap.
Repeat the procedure to install the second aileron
linkages in the opposite wing half
.
After both linkages are completed. connect both of
the aileron servo loads using a Y-harness you have
purchased.
Insert the 90 degree bend down through the hole in the
control horn. Install one nylon snap keeper over the
wire to secure it to the control horn. Install the control
horn retaining screw and remove the masking tape
from the aileron.
Flaslink
Pushrod wire Control horn
Bend and cut.
Silicone Tube
III. MAIN GEAR INSTALATION
Using a modeling knife, carefully remove the film cov
-
ering from the gear slots at the wing. Make sure that
you do not remove any wood from the slots.
PLASTIC FAIRING FOR LANDING GEAR.
Secure the gear to the wing.
Install the wheel pants.
4x15 mm
Secure
Bottom side.
Trim the covering.
3x15mm
Secure
Drill a hole
2.5mm
4x15 mm
3x15mm
5x33mm
3x10mm
