CANTER.
INSTRUCTION MANUAL
19
1. Cut out the switch hole using a modeling
knife. Use a 2mm drill bit and drill out the two
mounting holes through the fuselage side.
1. Plug the servo leads and the switch
lead into the receiver. You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.
2. Wrap the receiver and battery pack in
the protective foam to protect them from
vibration. Use a tie wrap or masking tape to
hold the foam in place.
INSTALLING THE SWITCH.
2. Secure the switch in place using the
two machine screws provided with the radio
system.
Switch.
INSTALLING THE RECEIVER AND BATTERY.
Tie wrap.
Receiver.
Tie wrap.
Battery.
WING ATTACHMENT.
1. Using a modeling knife, remove the cov-
ering fuselage.
Remove covering.
2.
Locate the aluminium wing dihedral
brace.
3.
Test fit the dihedral brace into fuse-
lage.
Do not permanently secure the receiver and
battery until after balancing the model.
3. Position the battery pack and receiver
behind the fuel tank. Use two tie wraps to hold
the battery and receiver securely in place as
pictures below
