CANTER.
INSTRUCTION MANUAL
17
6) When you are sure that everything is a
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
slot in the mounting platform and to the vertical
stabilizer mounting area. Apply epoxy to the
lower rudder hinge. Set the stabilizer in place
and re-align. Double check all of your
measurements once more before the epoxy
cures. Remove any excess epoxy using a
paper towel and rubbing alcohol and hold the
stabilizer in place with T-pins or masking tape.
Allow the epoxy to fully cure before proceeding.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
5. Put the vertical stabilizer back in
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90 degree
to the horizontal stabilizer.
Remove covering.
C/A glue.
Epoxy glue.
RUDDER CONTROL HORN INSTALLA-
TION.
Rudder control horn install as same as the
way of aileron control horn. Please see pic-
tures below.
Control horn of Rudder.
3mm x 40mm.
M3 lock nut
.
Nilon
control clasp.
Drill 6mm diameter a hole of the mounting
rudder control horn on to the rudder .
Mark point