CANTER.
Instruction Manual
16
2. Slide the rudder into the fuselage as
same as picture below.
Remove
covering.
3. Mark the shape of the vertical on the left
and right side on the rudder using a felt-tip
pen.
Pen.
Hinge slot.
4. Now, remove the rudder and using a
modeling knife, carefully cut just inside the
marked lines and remove the film of the rudder.
Just as you did with the horizontal stabilizer,
make sure you only press hard enough to cut
the film, not the balsa rudder.
1) Using a modeling knife, remove the
covering from the top of the fuselage and the
covering from over the precut hinge slot cut
into the lower rear portion of the fuselage This
slot accepts the lower vertical.
VERTICAL INSTALLATION.
Hinge.
Temporary pin to
keep hinge centered.
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
Cut the covering
away from the slot.
