Black+Decker HWVI225J01, Instruction Manual

Page: 8 / 16

8 • ENGLISH
WARNING: Do not attempt to modify or repair the
appliance
SAVE THESE INSTRUCTIONS
Symbols
• The label on your tool may include the following
symbols. The symbols and their definitions are as
follows:
V .......................volts
A .......................amperes
Hz.....................hertz
W......................watts
min ...................minutes
or AC ..........alternating current
or DC ......direct current
no .....................no load speed
....................Class I Construction
(grounded)
.....................earthing terminal
...................safety alert symbol
....................Class II Construction
(double insulated)
.../min or rpm...revolutions or reciprocation
per minute
FUNCTIONAL DESCRIPTION
1. On/off switch
2. Bowl release button
3. Charging socket
4. Dust bowl
5. Wet/Dry Filter
6. Wet/Dry Foam Insert
7. Squeegee
8. Charger
9. Jack plug
10. Wall mount bracket
WALL MOUNTING - FIGURE A
The product can be attached to a wall to provide a
convenient storage and charging point for the appliance.
When mounting to a wall, make sure the mounting method
is suitable for the wall type and is appropriate to the weight
of the appliance.
• Mark the location of the charger bracket (10) screw
holes on the wall (within reach of an electrical
outlet for charging the vacuum while it is on the wall
bracket).
• Fix the mounting bracket to the wall using appropriate
screws and plugs for the type of wall, and weight of
the appliance.
• Hang the appliance by placing the opening of the
vacuum base over the hooks in the wall mount
charging bracket.
ASSEMBLY ACCESSORIES - FIGURE B
• Insert the squeegee into the front of the appliance as
show in Figure B.
• Make sure the accessory is fully pushed in.
CHARGING THE BATTERY
From new, the rechargeable cells of the product need a
minimum charge time of 16 hours to ensure full power.
• The switch must be in the off (“O”) position, the
product will not charge if it is in any other position.
• Figure C - Plug the jack plug of the charger into the
charging socket of the tool. Plug the charger into any
standard 120 Volt 60 Hz electrical outlet or 220 Volts
50 Hz for the 220V models.
• While charging, the charger may get warm, this is
perfectly normal and safe. It is safe to leave the
appliance connected to the charger indefinitely. The
charger automatically reduces power consumption
when charging is complete.
WARNING:
Do not charge the battery at ambient
temperatures below 50 °F or above 104 °F.
SWITCHING ON - FIGURE D
Figure D - To start, slide the On/Off switch forward (i.e.
“O”= Off, “I” = On).
• To stop, slide the switch back.
• Return the product to the charger immediately after
use so that it will be ready and fully charged for the
next use. Plug the jack plug of the charger fully into
the charging socket of the vacuum.
DRY PICK UP
• For everyday spills of dry material.