English
9
Fig. P
20
• Push the cap onto the housing until it snaps securely
into place.
CAUTION:
To avoid trimmer damage, if the cutting
line protrudes beyond the trimming blade, cut it off so
that it just reaches the blade.
Rewinding Spool From Bulk Line (Fig.
Q—S)
(use only .065 in. ROUnD diameter line)
Bulk line is also available for purchase from your local
retailer.
nOTE:
Hand wound spools from bulk line are likely
to become tangled more frequently than BLACK+DECKER
factory wound spools. For best results, factory wound spools
are recommended.
To install bulk line, follow the steps below:
• Unplug trimmer.
• Remove the empty spool from the trimmer as described
in “REPLACING THE SPOOL”.
• Remove any remaining cutting line from the spool.
• Make a fold at the end of the cutting line at about 3/4"
(19 mm)
22
. Feed the cutting line into one of the line
anchoring slots
23
as shown in figure Q.
Fig. Q
23
22
• Insert the 3/4" (19 mm) end of the bulk line into the
hole
26
in the spool adjacent to the slot as shown in
figure R. Make sure the line is pulled tight against the
spool as shown in figure R.
Fig. R
26
28
• Wind the cutting line onto the spool in the direction of
the arrow on the spool. Make sure to wind the line on
neatly and in layers. Do not crisscross (Fig. S).
• When the wound cutting line reaches the recesses
28
,
cut the line. (Fig. R).
• Fit the spool onto the trimmer as described in
“REPLACING THE SPOOL”.
CAUTION:
Before you begin trimming, only use the
appropriate type of cutting line.
Fig. S
Troubleshooting
Trimmer Runs Slowly
1. Unplug the trimmer.
2. Check that the spool housing can rotate freely.
Carefully clean it if necessary.
3. Check that the cutting line does not protrude more
than approximately 5-3/8" (136 mm) from the spool.
If it does, cut it off so that it just reaches the line
trimming blade.
Repairs
WARNING:
To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement, when
applicable) should be performed by a BLACK+DECKER
factory service center or a BLACK+DECKER authorized
service center. Always use identical replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
•
WARRAnTY sERViCE:
Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
•
COnFiRMATiOn OF OWnERshiP:
In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
•
FOR YOUR sAFETY:
Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
Register online at
www.blackanddecker.com
