Black+Decker BDGP1518, Original Instructions Manual

Page: 9 / 76

9
ENGLISH
(Original instructions)
ALWAYS START AND STOP THE POLISHER
ON OR AGAINST THE SURFACE.
Place the
cord over your shoulder and do flat surfaces
first - hood, trunk and roof. Cover areas
quickly with broad, sweeping strokes in a
criss-cross pattern.
DO NOT press down on the polisher. The
machine’s action, not pressure, does the
best job.
• After flat surfaces are covered with wax,
do sides of the car. Let the cord hang
free. It is not necessary to use a
criss-cross motion on doors and fenders.
• Put a clean polishing bonnet on the
polisher
• Polish the wax. Use long, sweeping
strokes in a criss-cross pattern. Do not
press hard. Let the polisher do the work.
Warning!
Before working , let it operate for
no less one minute without load. First ,
ensure that the polisher disc is resting on
the work surface. Grasp polisher and turn it
on. Move it in long, sweeping strokes along
the surface, letting it do the work.
Handy hints
• This polisher is a random orbit polisher. it
is designed to wobble. The wobbling
motion produces the fine, swirl free
finish.
• For best results, use light pressure only,
letting the polisher do the work.
• Exercise caution around edges, corners
or small surface areas. Prolonged
polishing on edges and corners can
damage these areas.
• Polishing bonnet can be hand washed in
warm water and mild detergent. It can be
machine dried at the lowest setting
however air drying is recommended.
DO NOT USE ABRASIVE COMPOUNDS.
Liquid wax is recommended to use with
this polisher.
• The polishing bonnet is only to be used
for the final buff. Do not use it to apply
wax.
Maintenance
Your tool has been designed to operate over
a long period of time with a minimum of
maintenance. Continuous satisfactory
operation depends upon proper tool care
and regular cleaning.
Warning! Before performing any
maintenance, switch off and unplug
the tool.
• Regularly clean the ventilation slots in
your tool using a soft brush or dry cloth.
• Regularly clean the motor housing using
a damp cloth. Do not use any abrasive or
solvent-based cleaner.
Accessories
The performance of your tool depends on
the accessory used. BLACK+DECKER
accessories are engineered to high quality
standards and designed to enhance the
performance of your tool. By using these
accessories you will get the very best from
your tool.
Voltage
B5, B9 V 220-240
Power W 1300
Rated speed /min 3600
Disc diameter mm 180
Spindle size M14
Weight Kg 3.6
BDGP1518
Specification
Noise Lp dB(A) 93.0
Lw dB(A) 104.0
K dB(A) 3
Vibration a
h
m/s
²
3.1
K m/s
²
1.5