Black+Decker BDGP1518, Original Instructions Manual

Page: 8 / 76

ENGLISH
8
(Original instructions)
estimation of vibration exposure should
consider, the actual conditions of use and
the way the tool is used, including taking
account of all parts of the operating cycle
such as the times when the tool is switched
off and when it is running idle in addition to
the trigger time.
Use of extension cords
Make sure the extension cord is in good
condition before using. Always use the
proper size extension cords with the tool –
that is, proper wire size for various lengths
of cord and heavy enough to carry the
current the tool will draw. Use of an
undersized cord will cause a drop in line
voltage resulting in loss of power and
overheating. For proper size cords see chart
below.
Features
1. On/off switch
2. Variable speed switch
3. Lock-on button
4. Side handle
5. Spindle lock
Motor
Warning! Be sure your power
supply agrees with nameplate
marking.
Installation
Assembly and adjustment
• Place the polisher disk on the spindle,
mount the concave recess side of the
locking nut over the spindle, and tighten
with the two –hole spanner.
• Mount the outside spindle over the
spindle, Install the woolen fabrics cover
by simply stretching the elastic and
slipping the woolen fabrics cover over the
outside spindle. And let it operate for
more than three minutes for checking it
up without load.
Caution! Turn off and unplug from
power supply.
Before operating
Note:
Although this discussion deals with
polishing a car, your polisher is capable of
polishing a wide array of flat surfaces such
as hardwood floors, furniture, boats and
other surfaces that could use an occasional
shine. Before you begin, make sure the car is
clean and dry. The work area should be dry
also. If necessary, remove road tar with a
general cleaner before polishing. Also
remove excess grease spots, bug stains, etc.
Selecting the correct operating speed
The work speed of the rotating part is
controlled by the timing. Switch indicated in
figures. The further the switch is moved
away from its off position, such as from 1 to
2, the faster the work part rotates.
Operation
• Make sure the polisher is in the “OFF”
position before plugging the polisher into
an appropriate power outlet.
• To switch your polisher on, press the
on/off switch. To switch it off press the
on/off switch.
Minimum gage for cord sets
Volts Total length of cord in feet
120V~ 0-25 26-50 51-100 101-150
220V~ 0-50 51-100 101-200 201-300
Ampere rating
More No more American wire gage
than than
0 - 6 18 16 16 14
6 - 10 18 16 14 12
10 - 12 16 16 14 12
12 - 16 14 12 Not recommended