![background image](http://html.mh-extra.com/html/black-decker-1/bcw201/bcw201_instruction-manual_2766020008.webp)
English
6
Intended Use
Your BLACK+DECKER BCW201 sander has been designed
for sanding wood, metal, plastics and painted surfaces. This
tool is intended for consumer use only.
DO nOT
use under wet conditions or in presence of
flammable liquids or gases.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)
WARNING:
Never modify the power tool or any part
of it. Damage or personal injury could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.
The state of charge is an indication of approximate levels
of charge remaining in the battery according to the
following indicators:
96-100% charged
76-95%
51-75%
26-50%
Pack needs to be charged
To actuate the state of charge, press the state of charge
Indicator button. A combination of the four LEDs will
illuminate designating the level of charge left. When the
level of charge in the battery is below the usable limit, the
state of charge LEDs will either not light or the bottom LED
will blink.
nOTE:
The LED state of charge will only display once the
state of charge button is pressed.
Fig. D
8
•
Press state of charge button at anytime to display the
remaining level of charge.
nOTE:
The state of charge Indicator is only an indication
of the charge left on the battery. It does not indicate tool
functionality and is subject to variation based on product
components, temperature and end-user application.
nOTE:
GoPak battery terminal cap should be used when
battery is not connected to a power tool. Terminal cap is
provided for use whenever the battery is out of the tool.
Remove cap before placing battery into tool.
Fig. B
6
10
Charging the BLACK+DECKER GoPak 2 in 1
Battery (Fig. C, D)
WARNING:
Never attempt to charge the
BLACK+DECKER GoPak 2 in 1 battery using the tool
terminals on the GoPak.
WARNING:
You should only charge the
BLACK+DECKER GoPak 2 in 1 battery using UL or
CSA approved USB ports rated for charging high
performance devices. The GoPak can pull more
current than acceptable with older USB ports. An
error message may display on your computer if the
computer is used to charge the GoPak.
1. Plug the micro USB cable (included)
7
into a USB
power supply (not included).
2. Plug the micro USB plug of your charger cord into the
GoPak micro USB port
6
.
3. As the GoPak charges, the state of charge LEDs will
illuminate. The illuminated LED(s) indicate the state
of charge of the pack. The blinking LED indicates the
next level of charge in progress. The state of charge
button
8
is disabled during charging only.
4. The completion of charge is indicated by all four LEDs
turning off. Pressing the state of charge indicator
button
8
will illuminate all four LEDs. The battery is
fully charged and may be used at this time or left on
the charger.
5. Recharge discharged batteries as soon as possible
after use or battery life may be greatly diminished. For
longest battery life, do not discharge batteries fully. It
is recommended that the batteries be recharged after
each use.
Fig. C
6
7
State of Charge Indicator (Fig. D)
The BLACK+DECKER GoPak 2 in 1 battery is equipped with a
state of charge button
8
with a four LED display.
Summary of Contents for BCW201
Page 35: ......