![background image](http://html1.mh-extra.com/html/black-decker-1/2504231/2504231_instruction-manual_2766074009.webp)
English
7
SmartSelect
TM
Dial
The steam mop is equipped with a SmartSelect
TM
dial
3
which shows various hard surface cleaning applications. To
change the application, turn the SmartSelect
TM
dial until the
correct operating mode for your particular hard floor surface
is selected.
nOTiCE:
The dial has an "off" position. There will be no
steam flow when the dial is turned to this position
nOTiCE:
For garments and carpet, set the dial to to the
Wood/Laminate setting.
nOTiCE:
Do not use on any unsealed hard floor surfaces.
Additionally, on surfaces that have been treated with wax
or some no wax floors, the sheen may be removed by
the heat and steam action. It is always recommended to
test an isolated area of the surface to be cleaned before
proceeding. We also recommend that you check the use
and care instructions from the floor manufacturer.
Using the SmartSelect
TM
dial, choose from one of the
following applications. The steam mop will select the
correct volume of steam required for your particular
cleaning operation.
Steam Mop cleaning
1. Place a cleaning pad
21
on the floor with the ‘hook &
loop’ side facing up.
2. Lightly press it down onto the cleaning pad.
3. Plug the steam mop electric cord into the outlet.
4. Press the ON/OFF button
1
. It takes approximately 15
seconds for the steam mop to heat up.
5. Turn the SmartSelect
TM
dial
3
to the desired setting to
activate the steam pump. After a few seconds steam
will start to come out of the steam floor head at the rate
corresponding to the SmartSelect Dial setting..
nOTiCE:
If the system has been run dry it may take up to 30
seconds to prime the system on first use.
nOTiCE:
It takes a few seconds for steam to enter the
cleaning pad. The steam mop will now glide easily over the
surface to be sanitized/cleaned.
6. Push and pull the steam mop slowly across the floor to
thoroughly steam clean each section.
7. When you have finished using the steam mop, turn the
SmartSelect
TM
dial to off, unplug the steam mop, and wait
until the steam mop cools down (approximately five
minutes).
Steam Glove
WARNING: Always use the steam glove as
shown in figure L, with your hand inside the
protective glove.
WARNING: Never attempt to use the steam
glove by gripping it externally as shown in
figure M. This will result in scalding.
WARNING: Avoid using the steam glove in
tight corners as shown in figure N.
WARNING: Should a problem occur during
use, use the quick release tab (9) to quickly
remove the steam glove from your hand as
shown in figure O.
Figure L
Figure M
Figure N
Figure O
• Attach the steam glove
12
as shown in the "Attaching
the hose and steam glove" section.
nOTiCE:
The SmartSelect
TM
dial is disabled when the steam
glove is attached.
Attaching a cleaning pad
1. Insure steam glove is cool and not attached to hand-held
steam cleaner.
2. Fit a steam glove cleaning pad
16
to the steam glove
12
by attaching the velcro strips
35
on the back side of the
cleaning pad, to the velcro pads
36
on the underside of
the steam glove (figure P).
3. Press down firmly.